Robert Owens

Over A Brew AG setup - Robert Owens

photograph of AG setup - Robert Owens

Chimprage.com AG setup - Robert Owens

Souping Up Your Brewing setup - Robert Owens

The Northern Brewer Homebrew Forum - Robert Owens

MP Dixon's AG setup - Robert Owens

Here are the parts you will need for the conversion (see picture, left to right): * Rubbermaid 10 gallon round beverage cooler * all stainless steel ¼” hose clamps x 2 * brass square head plug (Watts A-737) * ½” x 12” (or larger) braided stainless steel supply hose * 3/8” female barb adapter (Watts A-298) * 5/8” stainless steel fender washer * 3/8” MIP x 1-1/2” brass nipple (Watts A-786) * seal from plastic spigot of cooler (shown below) * Teflon tape (note: everything to the left of the tape in the picture above goes inside the cooler, and everything to the right goes outside) * 5/8” O-ring (preferably heat resistant, if you can find one) * 3 x 5/8” fender washers * 3/8” threaded ball valve * 3/8” male barb adapter (Watts A-294) Assembly - Robert Owens

Igloo 60 Qt. Ice Cube Roller Cooler; spigot may be too high - Robert Owens

Rick Young's AG Setup - Robert Owens

Batch Sparging article - Robert Owens

Passow's AG setup - Robert Owens

Passow's AG setup - Robert Owens

TwoHeadsBrewing's kegging and AG setup proposal - Robert Owens

TwoHeadsBrewing's kegging and AG setup proposal - Robert Owens

Jared's AG setup - Robert Owens

Jared's AG setup - Robert Owens

Brew Logic Single Tap Draft System- with Reconditioned CO2 Tank - Robert Owens

Brew Logic Single Tap Draft System- with Reconditioned CO2 Tank - Robert Owens

Boerderij Kabouter's Suggested AG Starter Rig - Robert Owens

Boerderij Kabouter's Suggested AG Starter Rig - Robert Owens